[. . . ] 1) A B C D E 1 2 3 4 5 6 7 8 9 10 11 12 13 F 1 2 3 G Vents Lamp housing Mains cord Antenna Display Light symbol Hour indication of clock time/alarm time Clock time symbol Alarm symbol Radio symbol 'Birds' sound symbol `Beep' sound symbol `African jungle' sound symbol `Wind chimes' sound symbol Dusk function symbol Display brightness symbol Minute indication of clock/alarm time Sound level symbol Function selectors Top function selector: light on/off and light intensity Middle function selector (SET): menu and radio frequency Bottom function selector: radio on/off and volume Control lever with `alarm off ', `alarm on' and `snooze' positions important Read this user manual carefully before you use the appliance and save it for future reference. Do not let water run into the appliance or spill water onto the appliance (Fig. Warning Check if the voltage indicated on the appliance corresponds to the local mains voltage before you connect the appliance. the appliance is suitable for a mains voltage of 230V and a frequency of 50Hz. [. . . ] You can operate the function selectors in the following way: 1 Press the middle function selector (SET) to enter the menu. 2 Move the middle function selector (SET) up or down to select a function. 4 Move the middle function selector (SET) up or down to select a setting. Then move the top function selector up or down to select the light intensity level you prefer (2). Note:The light intensity you have selected is automatically set as the light intensity level for the alarm as well. Tip:When you use the appliance for the first time, set the light intensity to 20. The moment you wake up, check which light intensity level the appliance has reached by slightly moving the top function selector up or down. When you do this, the current alarm light intensity level appears on the display. Note:When you want to check the light intensity without switching on the lamp, you can also move the top function selector up or down to select a setting without pressing the function selector first. Setting the alarm When you set the alarm, you choose an alarm time and the type of sound you want to wake up to. The light intensity slowly increases to the selected level during the last 30 minutes before the set alarm time. The sound slowly increases in 90 seconds to the selected level after the set alarm time. Note:You can set the light intensity by turning the top function selector up or down and you can set the alarm volume by moving the bottom function selector up or down. If you do not want to wake up to the lamp or to a sound, select a light intensity or volume level of 0. see sections `Using the lamp' and `Radio/ Volume' in this chapter. 1 Push the control lever down to the middle position to switch on the alarm. 2 Move the middle function selector (SET) up or down to select the hour. If this is not the case, push the control lever up and down again to enter the alarm time mode. See section `Menu functions of middle function selector (SET)' in this chapter. 4 Move the middle function selector (SET) up or down to select the minutes. 5 Press the middle function selector (SET) to confirm or wait for a few seconds. Switching off the alarm To switch off the alarm function, push up the control lever to the top position. [. . . ] Perhaps there was a power failure that lasted more than approximately 15 minutes. In this case the appliance has remembered all settings except the clock time. The alarm did not go off Perhaps you pushed the control lever down with so much force that it 9 minutes after I pushed jumped to off position. The light wakes me too late Perhaps the light intensity level you have set is not appropriate for you. [. . . ]